Generating Hex file and debugging in keil uvision4:
The steps to generate HEX file, in Keil follow the below link
Social Profiles
-
ADC INTERFACING WITH LPC2138 An analog-to-digital converter ( ADC , A/D , or A to D ) is a device that converts a... -
In this section we will start programming LPC2138 with the brief introduction we had in the previous section. As described earlier in orde... -
Stepper Motor A stepper motor is a brushless , synchronous electric motor that can divide a full rotation into a large numbe... -
Generating Hex file and debugging in keil uvision4: The steps to generate HEX file, in Keil follow the belo...
-
GPIO Configurations for basic programming for ARM lpc2148 ARM 7 has two ports named as PORT0 and PORT1 Each port can be used as an... -
Simulate a program in proteus design suite: Steps to simulate the generated HEX file from KEIL in Proteus ...
-
/*LCD Count value display */ /*Connections from LPC2148 to LCD Module: P0.0 to P0.7 used as Data bits. P1.16 connected to pin... -
/* Connections from LPC2148 to LCD Module: P0.0 to P0.7 used as Data bits. P1.16 connected to pin4 i.e. RS - Command / Data ... -
In this section we will the discuss the basic requirements to write a program i.e to declare the bit stream Whenever we write the pr...
-
Program for LED blinking : /* connect PORT0 P0.16 – P0.15 to LEDs*/ #include<LPC213X.H> void delay(int); main() { PINSEL...
0 comments:
Post a Comment